![]() It will help the heating and cooling cycle have a lesser impact on the temperature swing inside the incubator. Question 7: I have a forced-air fan.should the fan always be on?Īnswer: Yes! This allows the air to continue to move and stay a uniform temperature. The warm spots and cool spots are minimized so your thermometer is a better representation of the temperature of each egg. It does this by keeping the temperature more uniform throughout the incubator. But most folks agree that a fan kit will increase the hatch-rate of your eggs. Question 6: Do I need a forced-air fan for my incubator?Īnswer: No. What do I do?Īnswer: Either the heater is not working properly or perhaps the room temperature is too cold for the heat generated by the incubator. Question 5:The red light stays on, indicating that the heater is staying on, but the incubator won't get warm enough. Just remove the chicks as they dry and place them in your brooder and let the other eggs in the turner keep on turning! As the chicks hatch, they should not be much of a bother to the eggs that are still being turned. This will open up some space in your incubator to lay the eggs on the wire screen. One solution is to simply remove the egg rack just from the section of your egg turner that has the eggs that need to stop being turned. Question 4: What if I have eggs in my incubator that started incubating on different days?Īnswer: This is a common problem for people who hatch eggs from their own birds. At that point, you remove the turner and just leave the eggs sitting on the wire mesh floor that is inside the incubator. This is a great question! How it works is that when hatching eggs, about three days before they are set to hatch, you are suppose to STOP turning them. ![]() If the auto turn is on, what do the first couple of hatched chicks do? Question 3: What happens when one chick hatches and the others haven't yet. See how much the temperature changes and then adjust accordingly. Then wait for the incubator temperature to stabilize. Question 2: How much should I turn the thermostat screw to adjust the temperature on my Hova-Bator 1602N egg incubator?Īnswer: Turn the adjustment screw one full turn in the direction indicated to raise or lower the temperature depending on which direction you need the temperature to go. One other difference is that the Hova-Bator comes with an easy to clean sanitary liner for the bottom of the incubator. The Little Giant has an electronic thermostat that comes preinstalled and is just a little simpler to adjust. But once it is set, it has proven to be a very good and reliable thermostat. It works great but you will need to install it (not very difficult and comes with good instructions) and setting the correct temperature is just a little trickier than the Little Giant. The Hova-Bator uses a mechanical wafer-style thermostat. First, the thermostats are very different. Question 1: What is the difference between the Little Giant incubator and the Hova-Bator incubator?Īnswer: Both incubators hold the same quantity of eggs.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |